Packet data access point settings
Select
Menu
>
Settings
and
Connectivity
>
Destinations
>
Access point
, and follow the instructions.
Edit a packet data access point
Select an access point group and access point marked with
. Follow the instructions from your service provider.
Select from the following:
Access point name — The access point name is provided by
your service provider.
User name — The user name may be needed to make a data
connection, and is usually provided by your service provider.
Prompt password — If you must enter the password every
time you log in to a server, or if you do not want to save your
password in the device, select
Yes
.
Password — A password may be needed to make a data
connection, and is usually provided by your service provider.
Authentication — To always send your password
encrypted, select
Secure
. To send your password encrypted
when possible, select
Normal
.
Homepage — Depending on the access point you are setting
up, enter the web address or the address of the multimedia
message centre.
Use access point — Set the device to connect to the
destination using this access point after confirmation or
automatically.
Modify advanced packet data access point settings
Select
Options
>
Advanced settings
.
Select from the following:
Network type — Select the internet protocol type to transfer
data to and from your device. The other settings depend on
the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of
your device.
DNS addresses — Enter the IP addresses of the primary and
secondary DNS servers, if required by your service provider.
To obtain these addresses, contact your internet service
provider.
Proxy server address — Enter the address of the proxy
server.
Proxy port number — Enter the port number of the proxy
server.
© 2011 Nokia. All rights reserved.
54